2006 Saab 9-2X Owner's Manual - Page 42

1-18 Seat, seatbelt and SRS airbags Seatbelt extender If the front seatbelts are not long enough to permit the tongue plate to engage with the seatbelt buckle, an optional seatbelt extender is available from your Saab dealer. When ordering an extender, only order one particularly designed for your vehicle. Several different types of extenders are available to match various varieties of front seatbelt designs. See your Saab dealer for assistance. The extender adds approximately 8 inches (200 mm) of length and it can be used for either the driver or front passenger seating position. For the safety of others, the extender should be removed after each use, especially if the next person using the seatbelt does not need one. Note that leaving the seatbelt extender's tongue plate engaged with the seatbelt buckle may prevent the Saab advanced front airbag system from functioning correctly or cause the system to fail. Be sure to observe the following when using the seatbelt extender. Failure to follow these instructions and warnings could reduce the effectiveness of the seatbelt and result in more serious injury in the event of a collision. — Never use the extender when the belt itself is long enough to permit it to be buckled properly. If removal of heavy clothing is all that is needed to permit the seatbelt to be buckled properly, remove the heavy clothing and do not use the extender. — Do not use the extender if the buckle of the extender rests over the abdomen. — Do not let someone else use the extender. Use of an extender when it is not needed could reduce the effectiveness of the seatbelt and result in more serious injury in the event of a collision. — Use the extender only for the front seatbelts and only for the model for which it was originally provided. Never use the extender for the rear seatbelts or for a different model. NOTE When the seatbelt extender is used by a pregnant passenger, consult a doctor to get approval in advance. 100605 To connect the extender to the seatbelt, insert the tongue plate into the seatbelt buckle so that the "PRESS" signs on the buckle-release buttons of the extender and the seatbelt are both facing outward as shown in the diagram. You will hear a click when the tongue plate locks into the buckle. When releasing the seatbelt, press on the buckle-release button on the extender, not on the seatbelt. This helps to prevent damage to the vehicle interior and extender itself.