2008 Subaru Impreza Owner's Manual - Page 128
2008 Subaru Impreza Manual
Page 128 highlights
3-12 Instruments and controls & Speedometer The speedometer shows the vehicle speed. The display can be switched as shown below by pressing the trip knob. & Odometer/Trip meter *: " " or " " cannot be displayed when the ignition switch is in the "ON" position. To change the current setting, press the trip knob for at least 2 seconds. : Activated : Deactivated NOTE . Your vehicle's initial movement setting of the meter/gauge needles has been set for activation " " at the time of shipment from the factory. . It is not possible to cancel the initial movement setting of the meter/gauge needles when the ignition switch is in the "ON" position. Cancel the setting when the ignition switch is in the "LOCK" or "Acc" position. 1) Trip knob *: " " or " " cannot be displayed when the ignition switch is in the "ON" position. " indication, refer to For the " " or " "Canceling the function for meter/gauge needle movement upon turning on the ignition switch" in this section. This meter displays the odometer and two trip meters when the ignition switch is in the "LOCK", "Acc" or "ON" position. If you press the trip knob when the ignition switch is in the "LOCK" position, the odometer/trip meter will light up. It is possible to switch the indications while the odometer/trip meter is lit up. If you do not press the trip knob within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will go off.