2008 Subaru Impreza Owner's Manual - Page 193
2008 Subaru Impreza Manual
Page 193 highlights
Audio 5-15 ! Category selection ! Channel scan & Channel preset ! How to preset channels 1. Press the "SAT" button to select SAT1, SAT2 and SAT3 reception. 2. Select the desired channel. 3. Press one of the preset buttons for more than 1.5 seconds to store the channel. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory. NOTE When in the SAT mode, press the "CAT" button " " or " " to change to the category search mode. When in the category search mode, pressing the "CAT" button " " changes the category up by one step. Pressing " " changes the category down by one step. When a category is selected, turning the "CH" dial selects channels only within the selected category. The control function returns to the normal mode after approximately 10 seconds. Press the "SCAN" button to change the radio to the SCAN mode. In this mode, under the selected category, the radio scans through the channel until a station is found. The radio will stop at the station for 5 seconds while displaying the channel number, after which scanning will continue until the entire channel has been scanned from the low end to the high end. Press the "SCAN" button again to cancel the SCAN mode and to stop on any displayed channel. If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset buttons. - CONTINUED -