2008 Subaru Impreza Owner's Manual - Page 249
2008 Subaru Impreza Manual
Page 249 highlights
Starting and operating 7-27 Gear shifts can be performed by using the selector lever. Using the selector lever Shift to the next-higher gear by briefly pushing the selector lever toward the "+" end of the manual gate. Shift to the next-lower gear by briefly pulling the selector lever toward the "−" end of the manual gate. shift is not possible. . If you attempt to shift up when the vehicle speed is too low, the transmission will not respond. . You can perform a skip-shift (for example, from 4th to 2nd) by operating the selector lever twice in rapid succession. . The transmission automatically selects 1st gear when the vehicle stops moving. . If the temperature of the automatic transmission fluid becomes too high, the "AT OIL TEMP" warning light will illuminate and upshifts to 4th gear will not be possible. Immediately stop the vehicle in a safe place and let the engine idle until the warning light goes off. In addition, sudden application of engine braking caused by down shifting when the vehicle is travelling on a slippery surface can lead to wheel locking; as a consequence, control of the vehicle may be lost and the risk of an accident increased. The following tables show the maximum speeds that are possible with each different gear. When down shifting, it is important to confirm that the current vehicle speed is not in excess of the Maximum Allowable Speed of the gear which is about to be selected. Non-turbo models mph (km/h) Gear position 1 2 3 Manual mode "D" position & Maximum speeds WARNING When down shifting, ensure that the vehicle is not travelling at a speed exceeding the Maximum Allowable Speed for the gear which is about to be selected. Failure to observe this precaution can lead to engine overrevving and this in turn can result in engine damage. 30 (48) 63 (101) 99 (160) NOTE Please read the following points carefully and bear them in mind when using the manual mode. . If you attempt to shift down when the engine speed is too high, i.e., when a downshift would push the tachometer needle beyond the red zone, beeps will be emitted to warn you that the down- - CONTINUED -