2008 Subaru Impreza Owner's Manual - Page 333
2008 Subaru Impreza Manual
Page 333 highlights
Maintenance and service 11-17 Air cleaner element WARNING Do not operate the engine with the air cleaner element removed. The air cleaner element not only filters intake air but also stops flames if the engine backfires. If the air cleaner element is not installed when the engine backfires, you could be burned. 7. Put the radiator cap back on and tighten firmly. At this time, make sure that the rubber gasket in the radiator cap is correctly in place. 8. Start and run the engine for more than five minutes at 2,000 to 3,000 rpm. 9. Stop the engine and wait until the coolant cools down (122 to 1408F [50 to 608C]). If there is any loss of coolant, add coolant to the radiator's filler neck and to the reserve tank's "FULL" level. 10. Put the radiator cap and reservoir cap back on and tighten firmly. & Replacing the air cleaner element Replace the air cleaner element according to the maintenance schedule in the "Warranty and Maintenance Booklet". Under extremely dusty conditions, replace it more frequently. It is recommended that you always use genuine SUBARU parts. ! Non-turbo models CAUTION When replacing the air cleaner element, use a genuine SUBARU air cleaner element. If it is not used, there is the possibility of causing a negative effect to the engine. The air cleaner element functions as a filter screen. When the element is perforated or removed, engine wear will be excessive and engine life shortened. The air cleaner element is unnecessary to clean or wash. 1) 2) 3) 4) Connector Clamp Air intake boot Clip 1. Unplug the connector that is attached to the top of the air cleaner case. 2. Loosen the screw of the clamp and pull the air intake boot out of the air - CONTINUED -