3Ware 9500S-4LP Installation Guide - Page 100
Installing the 3ware Driver on a FreeBSD System that Boots from a Different Device
UPC - 693494950045
View all 3Ware 9500S-4LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
Driver Installation Under FreeBSD TWA_FIRMWARE_FLASH opt_twa.h and the following line to your kernel configuration file ("custom" in the example above): options TWA_FLASH_FIRMWARE j If you intend to enable printing of debug messages in the driver, add the following line to /sys/conf/options: TWA_DEBUG opt_twa.h and the following line to your kernel configuration file ("custom" in the example above): options TWA_DEBUG= Specifying 0 in the above line prints no debug messages, whereas specifying 10 prints a LOT of debug messages. 11 Rebuild the kernel and install the new kernel. 12 Reboot with the rebuilt kernel. Installing the 3ware Driver on a FreeBSD System that Boots from a Different Device To install the 3ware driver as a module 1 Copy the driver from the 3ware CD-ROM at /packages/drivers/freebsd/ For FreeBSD 4.x, copy the driver into /modules For FreeBSD 5.x, copy the driver into /boot/kernel. 2 Load the driver kldload twa.ko If units are present, you should see unit information in the system log (usually, /var/log/messages). 92 3ware 9000 Series Serial ATA RAID Controller Installation Guide