3Ware 9500S-4LP Installation Guide - Page 102
Compiling the Driver as a Loadable Module, Rebuild the kernel and install the new kernel.
UPC - 693494950045
View all 3Ware 9500S-4LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Driver Installation Under FreeBSD h Add the following line to "Makefile.i386' CFLAGS+=-I/sys/dev/twa i If you intend to bundle the firmware image with the driver, add the following line to /sys/conf/options: TWA_FIRMWARE_FLASH opt_twa.h and the following line to your kernel configuration file ("custom" in the example above): options TWA_FLASH_FIRMWARE j If you intend to enable printing of debug messages in the driver, add the following line to /sys/conf/options: TWA_DEBUG opt_twa.h and the following line to your kernel configuration file ("custom" in the example above): options TWA_DEBUG= Specifying 0 in the above line prints no debug messages, whereas specifying 10 prints a LOT of debug messages. 5 Rebuild the kernel and install the new kernel. 6 Reboot with the rebuilt kernel. Compiling the Driver as a Loadable Module If you wish to compile the driver yourself (for a different kernel version that you are running), then perform the following steps. 1 Create the directories /sys/modules/twa and /sys/dev/twa mkdir /sys/modules/twa mkdir /sys/dev/twa 2 Copy the 3ware driver source file archive (twa.tgz) to /sys/dev/twa. 94 3ware 9000 Series Serial ATA RAID Controller Installation Guide