3Ware 9650SE-2LPB-10 CLI Guide - Page 53

Controller Object Commands A status of "disabled" indicates that the task schedule is disabled. In this case, the controller will not use the defined schedule timeslots. If the rebuild command is entered manually, rebuilding will start within 10 to 15 minutes. It will begin automatically if a rebuild is needed and a proper spare drive is set up. If the rebuild schedule is enabled while a rebuild process is underway, the rebuild will pause until a scheduled time slot. Example: If a unit is in the initialization state at noon on Wednesday and the rebuild schedule shown above is in use (with schedules disabled), you would see the following status using the show command: $ tw_cli /c1 show Unit UnitType Status %RCmpl %V/I/M Stripe Size(GB) Cache AVrfy u0 RAID-5 INITIALIZING 0 - 64K 521.466 ON OFF Port Status Unit Size Blocks Serial p0 NOT-PRESENT - - - - p1 OK u0 76.33 GB 160086528 Y2NXL7FE p2 NOT-PRESENT - - - - p3 OK u0 76.33 GB 160086528 Y2NXLB9E p4 NOT-PRESENT - - - - p5 OK u0 76.33 GB 160086528 Y2NXQPZE p6 NOT-PRESENT - - - - p7 OK u0 76.33 GB 160086528 Y2NXM4VE p8 OK u0 74.53 GB 156301488 3JV3WTSE p9 OK u0 74.53 GB 156301488 3JV3WRHC p10 OK u0 74.53 GB 156301488 3JV3WQLQ p11 OK u0 74.53 GB 156301488 3JV3WQLZ Name OnlineState BBUReady Status Volt Temp Hours LastCapTest bbu On Yes OK OK OK 0 xx-xxx-xxxx If you then enable the rebuild schedules, the unit initialization will be paused until the next scheduled time slot, as reflected in the examples below: //localhost> /c1 set rebuild=enable Enabling scheduled rebuilds on controller /c1 ...Done. //localhost> /c1 show rebuild Rebuild Schedule for Controller /c1 Slot Day Hour Duration Status 1 Mon 2:00pm 10 hr(s) enabled 2 Thu 7:00pm 18 hr(s) enabled 3 - - - - 4 - - - - 5 - - - - 6 Mon 1:00am 4 hr(s) enabled 7 Sun 12:00am 1 hr(s) enabled $ tw_cli /c1 show Unit UnitType Status %RCmpl %V/I/M Stripe Size(GB) Cache AVrfy www.3ware.com 47