3Ware 9650SE-2LPB-10 CLI Guide - Page 58

Chapter 2. CLI Syntax Reference Note: If you do not enable autoverify for units or start a verification manually, your verify schedule will not run, even if it is enabled with the /cx set verify=enable command. Warning: If all time slots are removed, be sure to also disable the schedule. Otherwise the applicable background task will never occur /cx add selftest=ddd:hh This command adds a new background selftest task to be executed on the day ddd (where ddd is Sun, Mon, Tue, Wed, Thu, Fri, and Sat), at hour hh (range 0 .. 23). Notice that selftest runs to completion and as such no duration is provided. A maximum of seven selftest tasks can be scheduled. This command will fail if no (empty) task slot is available. Example: //localhost> /c1 add selftest=Sun:16 adds a selftest background task schedule to be executed on Sundays at 16 hours (4:00 PM). Setting Up a Selftest Schedule Setting up a selftest schedule requires several steps, and several different CLI commands in addition to /cx add selftest. To set up the selftest schedule you want to use, follow this process: 1 Use the /cx show selftest command to display the current schedule for selftest tasks. (For details, see page 49.) 2 If any of the scheduled tasks do not match your desired schedule, use the /cx del selftest command to remove them. (For details, see page 53.) 3 Use the /cx add selftest command to create the selftest schedule slots you want (described above.) 4 Use the /cx set selftest=enable command to enable the schedule (this enables all selftest schedule slots). (For details, see page 54.) 52 3ware Serial ATA RAID Controller CLI Guide