AIWA XH-A1000 Operating Instructions - Page 22

RECORDING AI EDIT RECORDING CD EDIT/ CHECK 0-9,+10 DISC DIRECT PLAY q CD c/d f,g s The AI edit recording function enables CD recording without worrying about tape length and track length. When a CD is inserted, the unit automatically calculates the total track lengths. If necessary, the order of tracks is rearranged so that no track is cut short. (AI: Artificial Intelligence) 6 Press qREC/REC MUTE, and then press c/d within 2 seconds to start recording. The tape is rewound to the beginning of the side facing upward, the lead segment is played through for 10 seconds, and recording starts. When recording on the side facing upward (side A) ends, recording on the other side (side B) starts. To stop recording Press s. Recording and CD play stop simultaneously. To clear the edit program Press s twice so that the line of EDIT disappears from the display. To check the order of the edit program Before recording, press CD EDIT/CHECK to select side A or B, and press f or g repeatedly. Track Tape side number Program Programmed number track numbers NOTE The AI edit recording will not start from a point halfway into the tape. The tape must be recorded from the beginning of either side. Use the remote control from steps 3 to 6. 1 Load the tape into the cassette tray, and press DOLBY NR to turn Dolby NR on or off. Load the tape with the side to be recorded on first facing upward. 2 Press CD and load the disc(s). 3 Press CD EDIT/CHECK once. The lines of AI EDIT and "AI" light up on the display. AI AI EDIT To add tracks from other discs to the edit program If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment. 1 Press CD EDIT/CHECK to select side A or B. 2 Press DISC DIRECT PLAY, then press one of the numbered buttons 1-3 within 3 seconds to select a disc. En 3 Press the numbered buttons 0-9 and +10 to select tracks. A track whose playing time is longer than the remaining time cannot be programmed. 4 Repeat steps 2 and 3 to add more tracks. 5 Start recording. The line of AI lights off and the line of PRGM lights up. Time on cassette tapes and editing time The actual cassette recording time is usually a little longer than the specified recording time printed on the label. This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape's specified recording time after editing, the display shows the extra time (without a minus mark), instead of the time remaining on the tape (with the minus mark). When "PRGM" is selected, press CD EDIT/CHECK again. 4 Press DISC DIRECT PLAY, then press one of the numbered buttons 1-3 within 3 seconds to select a disc. 5 Press the numbered buttons 0-9 to designate the tape length. 10 to 99 minutes can be specified. Example: When using a 60-minute tape, press 6 and 0. In a few seconds, the tracks to be recorded on each side of the tape are determined. • f, g and MULTI JOG are also available to designate the tape length. Tape length Tape side A (facing upward) Selected tracks for side A NOTE • Recording is inhibited if the erasure prevention tab on either side of the tape is broken off. • The AI edit function cannot be used with discs containing 31 tracks or more. "TR OVER" is displayed if this is attempted. Remaining time of side A ENGLISH 21