Alpine CDE-W265BT Owner's Manual (english) - Page 56
Installation
View all Alpine CDE-W265BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Installation To prevent external noise from entering the audio system. • Locate the unit and route the leads at least 10 cm away from the car harness. • Keep the battery power leads as far away from other leads as possible. • Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis. • If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information. • Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. CAUTION When you install this unit in your car, do not remove the detachable front panel. If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place. The main unit must be mounted within 35 degrees of the horizontal plane, back to front. CDE-W265BT CDE-164BT Mounting Sleeve (Included) Dashboard Pressure Plates* This unit * If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem. 2 Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot. Connect each input lead coming from an amplifier to the corresponding output lead coming from the left rear of the CDE-W265BT/CDE-164BT. Connect all other leads of the CDE-W265BT/CDE-164BT according to details described in the CONNECTIONS section. CDE-W265BT Screw Hex Nut (M5) Less than 35° CDE-164BT Metal Mounting Strap * Bolt Stud Less than 35° 1 Remove the mounting sleeve from the main unit (refer to "Removal" on page 57). CDE-W265BT Mounting Sleeve (Included) Dashboard This unit CDE-164BT Hex Nut (M5) Metal Mounting Strap This unit Screw * Bolt Stud Pressure Plates* This unit Note • For the screw marked "*", use an appropriate screw for the chosen mounting location. 3 Slide the CDE-W265BT/CDE-164BT into the dashboard until it clicks. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the detachable front panel. 56-EN