Asus TRL-DLS TRL-DLS User Manual - Page 28
rotation signal. The Rotations Per Minute RPM can be monitored using Intel LDSM
View all Asus TRL-DLS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
3. HARDWARE SETUP 7) CPU and Chassis Fan Connectors (3-pin CPUFAN1/2, SYSFAN1/2) These connectors support cooling fans of 860mA (10.3 Watts) or less. Orient the fans so that the heat sink fins allow airflow to go across the onboard heat sink(s) instead of the expansion slots. Depending on the fan manufacturer, the wiring and plug may be different. The red wire should be positive, while the black should be ground. Connect the fan's plug to the board taking into consideration the polarity of the connector. NOTE: The "Rotation" signal is to be used only by a specially designed fan with rotation signal. The Rotations Per Minute (RPM) can be monitored using Intel LDSM Utility (provided with certain models). WARNING! The CPU and/or motherboard will overheat if there is no airflow across the CPU and onboard heatsinks. Damage may occur to the motherboard and/or the CPU fan if these pins are incorrectly used. These are not jumpers, do not place jumper caps over these pins. ® TRL-DLS CPUFAN1 SYSFAN2 GND +12V Rotation Rotation +12V GND CPUFAN2 SYSFAN1 GND +12V Rotation Rotation +12V GND TRL-DLS 12-Volt Cooling Fan Power 3. H/W SETUP Connectors 28 ASUS TRL-DLS User's Manual