Brother International BAS-341F Instruction Manual - English - Page 21

Pretension tension, Detection precision : DIP switch B - 5, Refer to DIP SWTCH .

Get Brother International BAS-341F PDF manuals and user guides View all Brother International BAS-341F manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

5-6-6. Pretension tension 5. CORRECT USE 1940S 1. Raise the work clamp (1) and open the main tension disc (2). The thread take-up spring (3) should not operate when the thread is pulled in the direction of the arrow. 2. Set the thread tension for the thread breakage detector pretension (4) to approx. 5 g. Weaken the thread tension for the machine head pretension (5) as much as possible. Standard for balance of thread tension Adjust the thread tensions so that the total tension for the pretensions (4) and (5) is lower than the tension for the thread take -up spring. When the thread breakage detector is activated, set to ON DIP switch A - 8. (Detection precision : DIP switch B - 5, Refer to " DIP SWTCH ".) Note If misoperation of the thread breakage detector continues, repeat the adjustment procedure above. (Such misoperation is most likely to occur when synthetic fiber yarns are used.) BAS-341F, 342F 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
5. CORRECT USE
BAS-341F, 342F
14
5-6-6.
Pretension tension
1. Raise the work clamp (1) and open the main tension disc (2).
The thread take-up spring (3) should not operate when the thread is pulled in the direction of the arrow.
2. Set the thread tension for the thread breakage detector pretension (4) to approx. 5 g.
Weaken the thread tension for the machine head pretension (5) as much as possible.
Standard for balance of thread tension
Adjust the thread tensions so that the total tension for the pretensions (4) and (5) is lower than the tension for the thread
take -up spring.
When the thread breakage detector is activated, set to ON DIP switch A – 8.
(Detection precision : DIP switch B – 5, Refer to “ DIP SWTCH “.)
Note
If misoperation of the thread breakage detector continues, repeat the adjustment procedure above.
(Such misoperation is most likely to occur when synthetic fiber yarns are used.)
1940S