Brother International BAS-341F Instruction Manual - English - Page 57
Error Codes
View all Brother International BAS-341F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
12. ERROR CODES 12. ERROR CODES Note • If an operation problem occurs, a buzzer will sound and an error code will appear on the display screen; if a programmer is connected, an error message will appear on the screen. • Wait 10 seconds or more after turning the power off before turning it back on again. Code E.10 E.11 E.12 E.20 E.21 E.22 E.30 E.31 E.32 E.40 E.41 E.43 E.4F Cause Remedy Emergency stop switch was pressed. Press the emergency stop switch once more to cancel. Emergency sewing. stop switch was pressed during Press the emergency stop switch once more to cancel. The STEP BACK switch can then be used to resume sewing. Emergency stop switch is being continually pressed, or emergency switch connection error. Turn off the power and check. Turn off the power, and then turn the machine pulley to Problem with machine motor stopping, or check if the machine has locked up. Check the synchronizer connection error. synchronizer connection. Check if connectors P14, P15 or P16 are disconnected. Machine motor operation error. Turn off the power and check the ground wire connection. Needle up stop position error. Turn the pulley to align the index mark with the needle up stop position. Check the V-belt tension. Data is outside possible sewing area enlargement or reduction ratio setting. due to Check the enlargement or reduction ratio setting. Data pitch exceeds 12.7 mm due to enlargement or reduction ratio setting. Check the enlargement or reduction ratio setting. No end code was input into sewing data. Input an end code, or change the program number. Floppy disk is not inserted, disconnected cord inside operation panel, or malfunction of drive. Insert a floppy disk. If floppy disk is already inserted, turn off the power and check the connections of cords inside the operation panel. Program number is invalid, no data, or floppy disk is not formatted. Check the floppy disk. Floppy disk changed from readable disk when setting the bobbin thread or when setting the Replace with a readable floppy. memory switch. Other error when reading floppy disk. Replace the floppy disk and repeat the operation. E.50 Floppy disk is write-protected. Remove the write-protection. E.51 Insufficient space on floppy disk. Use a different floppy disk. E.52 Floppy disk cannot be formatted Replace the floppy disk and repeat the operation. E.5F E.60 E.61 E.70 E.80 E.81 Floppy disk write error. Repeat the operation. Data backup is not possible. Data cannot be backed up Turn off the power, wait a while and then turn it back on. If the error appears continually, contact a qualified service technician. Overlapping option output numbers. Change the option output number. Thread breakage error detected by rotating-type thread breakage detector device. Thread the upper thread. Sewing can then resume. Upper thread breakage error detected by optical fiber-type sensor. Thread the upper thread. Sewing can then resume. BAS-341F, 342F 50