Brother International BES-1240BC Instruction Manual - English - Page 250
Error, Measures, Y-axis home position detection error
View all Brother International BES-1240BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
Chapter 11 List of Error Codes Code E-00 E-01 E-02 E-03 E-04 E-05 E-06 E-07 E-08 E-09 E-0A E-0B E-0C E-0D E-0E E-14 E-15 E-16 E-17 Error No error occurs. Measures This is not usually displayed. Either motor of main shaft, X- or Y-axis, or This is not usually displayed. lower shaft has locked. Overtravel occurs during home position Turn the power off once, then on again. If the same detecting movement. error occurs again, the area sensor is faulty. The stop switch is pressed during home Press and clear the error message. Pressing START START position detecting movement. restarts the home position detecting movement again. Zero detecting movement out of range This is not usually displayed. Needle stop position error Needle bar case position error Adjust the pulley stop position (100°) above the needle and press . STOP This is not usually displayed. Needle bar case lock Press . If the error persists, the color-change STOP mechanism is faulty. Stop switch or emergency switch was pressed while the needle bar case is traveling. Press . STOP X-axis home position detection error Turn the power off once, then on again. If the same error occurs again, the X-axis mechanism is faulty. Thread breakage error Stop or emergency stop during sewing After passing through the thread, press . STOP This is not usually displayed. Insufficient bobbin thread This is not usually displayed. The machine does not return to the home position. Turn the power off, then on again. Mending finish This is not usually displayed. Y-axis home position detection error Turn the power off once, then on again. If the same error occurs again, the Y-axis mechanism is faulty. Stop key was pressed while hoop was moving during non-sewing. Needle with specified number sent from This is not usually displayed. PC is out of movable area. Speed Vol. No. sent from PC is out of range. This is not usually displayed. 248 BES-940BC • BES-1240BC