Brother International BES-1240BC Instruction Manual - English - Page 260
Electrical
View all Brother International BES-1240BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
Chapter 12 Trouble Shooting Electrical Section Cautions • Be sure to turn off the power of the machine and unplug the power cord before checking cable connections. • When you check connection of the cables as instructed in this manual, also check connection and continuity between connectors. • Carry out items described in the "Measures" section in order of appearance. • Some checks and replacement works can be conducted only by repair people. In such cases, contact your dealer. Symptom Measures The machine does not operate even if the power is turned on. • Is the power cord of the machine plugged in? Plug in the power cord. • Is the connector at the rear of the control box connected? Connect it after checking the connector number and the harness number. • Is the connector in the control box or the power supply base connected? Connect it after checking the types and colors of the connectors. • Is fuse F1 or F2 on the power PCB in the power supply base blown? Replace the fuse with a new one. If the fuse is blown again, something is faulty. Check to see if the wiring is correct. Replace the control box with a new one. The machine does not operate even if the power is turned on. The message, "Release stop SW to operate!", is displayed on the panel. • Is the stop switch turned on? Reset the stop switch. • The message, "Is the presser foot removed?", is displayed on the machine controller when the power is turned on. • The red LED of head 2 or 4 does not light and the presser foot remains lowered. • Is the retract bed sensor adjusted properly? Adjust the retract bed sensor of the faulty head. (Refer to "Replacing the retract bed sensor PCB".) • Refer to the block diagram showing cable connection and check connection from the retreat bed sensor to the main PCB. • Check to see if the frame type is set to every other head with the machine controller. An overtravel error occurs. • Is the frame within the cap frame area? Move the frame within the cap frame area and turn on the power. • Check to see if the signal of the X area sensor turns ON and OFF in PORT test mode. When the signal does not change, refer to the block diagram showing the cable connections and check to see if connection from the X area sensor to the main PCB is proper. Replace the X area sensor with a new one. The needle stop position error occurs. • Is the pulley manually turned and out of the stop angle? Turn the pulley, adjust the needle at the stop position, and reset the error. • Check the signal of the stop position sensor in the encoder test mode. Refer to the adjustment or cable connection block diagram and check connection from the needle position detention sensor to the main PCB. Replace the needle position detection sensor with a new one. 258 BES-940BC • BES-1240BC