Brother International BES-1240BC Instruction Manual - English - Page 251
Measures, Error, Hoop overhang +X, +Y, -Y
View all Brother International BES-1240BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 251 highlights
Chapter 11 List of Error Codes Code E-18 E-1A E-1B E-1C E-1D E-1E E-21 E-22 E-23 E-24 E-25 E-26 E-27 E-28 E-29 E-2A E-2B E-2C E-2D E-2E E-2F E-31 E-32 Error X-axis stepping motor connector error Measures Turn off the power and check to see that the connector of the X-axis stepping motor is connected, then turn the power on again. Distination coordinates error This is not usually displayed. The machine has reached the mending This is not usually displayed. stop position. The machine stops during mask tracing. Press to reset tracing. Press STOP tracing. to continue The machine stops while the needle is moving between patterns during repeat sewing. Press to continue operation. START E-1C and E-1D errors are not caused by mechanical problems. When the power is turned on, bed can not be retracted. Remove the presser foot of the retreat bed. The retreat sensor is faulty if it is not retreated. Hoop overhang (+X) Hoop overhang (+Y) Hoop overhang (+X, +Y) Hoop overhang (-X) Hoop overhang (+X, -X) Hoop overhang (-X, +Y) Hoop overhang (+X, -X, +Y) Hoop overhang (-Y) Hoop overhang (+X, -Y) Hoop overhang (+Y, -Y) Hoop overhang (+X, +Y, -Y) Hoop overhang (-X, -Y) Hoop overhang (+X, -X, -Y) Hoop overhang (-X, +Y, -Y) Hoop overhang (+X, -X, +Y, -Y) Needle overhang (+X) Needle overhang (+Y) BES-940BC • BES-1240BC 249