Casio CTK7000 User Guide - Page 80
Using Panel Record to Rewrite, Song Header Settings
View all Casio CTK7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Using the Song Sequencer 6. Use the R-17 (u, i) buttons to move the cursor, use the dial or the R-14 (-, +) buttons to change the value at the cursor position, and then press the R-16 (ENTER) button. • If you have already specified a range using the locator screen (page E-80), you can copy that range to this screen by holding down the L-13 (REPEAT) button. Recording start point Recording end point 7. After specifying the recording start point and end point, press the L-17 (START/STOP) button. • This starts punch-in playback. You can perform fast forward and fast backward operations during punch-in playback using the operations described in step 6 under "To start re-recording from a particular location during playback (Manual Punch-in)" (page E-76). • You can start punch-in playback from one measure prior to the current recording start point by pressing the L-13 (REPEAT) button which causes the ? indicator to appear on the display. 8. When playback reaches the re-record point you specified, start playing something on the keyboard. • Punch-in recording will start automatically when playback reaches the record start point you specified. The C-6 (RECORD) button will light when recording starts. • Recording stops and punch-in recording is exited automatically when the record end point you specified is reached. At this time the C-6 (RECORD) button will become unlit. • If you want to stop recording before the record end point you specified is reached, press the L-17 (START/ STOP) button. Any previously recorded data in the track that comes after the point you stopped punch-in recording will remain in the track. • When "EOT" (End of Track) is selected for the recording start point, the start point for punch-in recording is the end of the track. • When "OFF" is selected for the recording end point, punch-in recording will not stop automatically because no end point is specified. To stop punch-in recording in this case, press the L-17 (START/STOP) button. Using Panel Record to Rewrite Song Header Settings The header of each song contains "header settings", which are settings that were in effect on the Digital Keyboard when recording was performed. You can use a "panel record" operation to rewrite a song's header settings with the Digital Keyboard's current setup. The following items are header settings that can be rewritten using the panel record operation. • Rhythm selection • Tempo setting • Scale setting • The mixer settings below - All part parameters from A04 through A07 and B01 through B16 (Excluding part on/off) - Part parameters from A09 through A16: part on/off, coarse tune, fine tune, scale enable, DSP line - DSP parameters: volume, pan, reverb send • Effect settings • Accomp volume • UPPER 1 part tone, UPPER 2 part tone, and LOWER part tone selections To perform a panel record operation 1. Press the C-5 (SONG SEQUENCER) button to enter the song sequencer mode. 2. Use the dial or R-14 (-, +) buttons to select a song area number. 3. Configure panel settings so they reflect the settings you want to write as the header settings. • You can configure the following settings: mixer settings, tempo, system track rhythm, track tone selection, etc. • To change the system track UPPER 1, UPPER 2, and LOWER part tones or mixer settings, use the mixer to change the settings of parts A05 (UPPER 1), A06 (UPPER 2), and A07 (LOWER). 4. After all of the panels settings are the way you want, hold the R-13 (FUNCTION) button as you press the C-17 (MENU) button. • This displays the song sequencer menu. E-78