Cisco 2950G 24 Software Configuration Guide - Page 144
Management VLAN, LRE Profiles
UPC - 746320687711
View all Cisco 2950G 24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Planning a Switch Cluster Chapter 6 Clustering Switches Management VLAN Communication with the switch management interfaces is through the command-switch IP address. The IP address is associated with the management VLAN, which by default is VLAN 1. To manage switches in a cluster, the command switch, member switches, and candidate switches must be connected through ports assigned to the command-switch management VLAN. Note • If the command switch is a Catalyst 2950 running Release 12.1(9)EA1 or later, candidate and member switches can belong to different management VLANs. However, they must connect to the command switch through their management VLAN. • Catalyst 2950 standby command switches running Release 12.1(9)EA1 or later can connect to candidate and member switches in VLANs different from their management VLANs. • This section applies Catalyst 2900 LRE XL switches only and is not applicable for the Catalyst 2950 LRE switch. If you add a new, out-of-box switch to a cluster and the cluster is using a management VLAN other than the default VLAN 1, the command switch automatically senses that the new switch has a different management VLAN and has not been configured. The command switch issues commands to change the management VLAN of the new switch to the one the cluster is using. This automatic VLAN change only occurs for new, out-of-box switches that do not have a config.text file and that have no changes to the running configuration. For more information, see the "Discovery of Newly Installed Switches" section on page 6-10. You can change the management VLAN of a member switch (not the command switch). However, the command switch will not be able to communicate with it. In this case, you will need to manage the switch as a standalone switch. You can globally change the management VLAN for the cluster as long as each member switch has either a trunk connection or a connection to the new command-switch management VLAN. From the command switch, use the cluster management vlan global configuration command to change the cluster management VLAN to a different management VLAN. Caution You can change the management VLAN through a console connection without interrupting the console connection. However, changing the management VLAN ends your CMS session. Restart your CMS session by entering the new IP address in the browser Location field (Netscape Communicator) or Address field (Microsoft Internet Explorer), as described in the release notes. For more information about changing the management VLAN, see the "Management VLAN" section on page 6-18. LRE Profiles A configuration conflict occurs if a switch cluster has Long-Reach Ethernet (LRE) switches that use both private and public profiles. If one LRE switch in a cluster is assigned a public profile, all LRE switches in that cluster must have that same public profile. Before you add an LRE switch to a cluster, make sure that you assign it the same public profile used by other LRE switches in the cluster. A cluster can have a mix of LRE switches that use different private profiles. 6-18 Catalyst 2950 Desktop Switch Software Configuration Guide 78-14982-01