Cisco 2950G 24 Software Configuration Guide - Page 546

Displaying QoS Information Chapter 26 Configuring QoS To disable the WRR scheduler and enable the strict priority scheduler, use the no wrr-queue bandwidth global configuration command. Displaying QoS Information To display QoS information, use one or more of the privileged EXEC commands in Table 26-5: Table 26-5 Commands for Displaying QoS Information Command show class-map [class-map-name]1 show policy-map [policy-map-name [class class-name]]1 show mls qos maps [cos-dscp | dscp-cos]1 show mls qos interface [interface-id] [policers]1 show mls masks [qos | security]1 Purpose Display QoS class maps, which define the match criteria to classify traffic. Display QoS policy maps, which define classification criteria for incoming traffic. Display QoS mapping information. Maps are used to generate an internal DSCP value, which represents the priority of the traffic. Display QoS information at the interface level, including the configuration of the egress queues and the CoS-to-egress-queue map, which interfaces have configured policers, and ingress and egress statistics (including the number of bytes dropped).2 Display details regarding the masks3 used for QoS and security ACLs. show wrr-queue cos-map Display the mapping of the CoS priority queues. show wrr-queue bandwidth Display the WRR bandwidth allocation for the CoS priority queues. 1. Available only on a switch running the EI. 2. You can define up to 13 DSCP values for which byte or packet statistics are gathered by hardware by using the show mls qos interface statistics privileged EXEC command. 3. Access control parameters are called masks in the switch CLI commands and output. 26-28 Catalyst 2950 Desktop Switch Software Configuration Guide 78-14982-01