Cisco 2950G 24 Software Configuration Guide - Page 541

Chapter 26 Configuring QoS Configuring QoS Command Purpose Step 5 set {ip dscp new-dscp} Classify IP traffic by setting a new value in the packet. For ip dscp new-dscp, enter a new DSCP value to be assigned to the classified traffic. The supported DSCP values are 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46, 48, and 56. Step 6 police rate-bps burst-byte [exceed-action {drop | dscp dscp-value}] Define a policer for the classified traffic. You can configure up to 60 policers on ingress Gigabit-capable Ethernet ports and up to 6 policers on ingress 10/100 Ethernet ports. For rate-bps, specify average traffic rate in bits per second (bps). The range is 1 Mbps to 100 Mbps for 10/100 Ethernet ports and 8 Mbps to 1000 Mbps for the Gigabit-capable Ethernet ports. For burst-byte, specify the normal burst size in bytes. The values supported on the 10/100 ports are 4096, 8192, 16384, 32768, and 65536. The values supported on the Gigabit-capable Ethernet ports are 4096, 8192, 16348, 32768, 65536, 131072, 262144, and 524288. (Optional) Specify the action to take when the rates are exceeded. Use the exceed-action drop keywords to drop the packet. Use the exceed-action dscp dscp-value keywords to mark down the DSCP value and send the packet. Step 7 exit Return to policy-map configuration mode. Step 8 exit Return to global configuration mode. Step 9 interface interface-id Enter interface configuration mode, and specify the interface to attach to the policy map. Valid interfaces include physical interfaces. Step 10 service-policy input policy-map-name Apply specified policy map to the input of a particular interface. Only one policy map per interface per direction is supported. Step 11 end Return to privileged EXEC mode. Step 12 show policy-map [policy-map-name class Verify your entries. class-name] Step 13 copy running-config startup-config (Optional) Save your entries in the configuration file. To delete an existing policy map, use the no policy-map policy-map-name global configuration command. To delete an existing class map, use the no class class-map-name policy-map configuration command. To remove an assigned DSCP value, use the no set ip dscp new-dscp policy-map configuration command. To remove an existing policer, use the no police rate-bps burst-byte [exceed-action {drop | dscp dscp-value}] policy-map configuration command. To remove the policy map and interface association, use the no service-policy input policy-map-name interface configuration command. This example shows how to create a policy map and attach it to an ingress interface. In the configuration, the IP standard ACL permits traffic from network 10.1.0.0. For traffic matching this classification, the DSCP value in the incoming packet is trusted. If the matched traffic exceeds an average traffic rate of 5000000 bps and a normal burst size of 8192 bytes, its DSCP is marked down to a value of 10 and sent. 78-14982-01 Catalyst 2950 Desktop Switch Software Configuration Guide 26-23