Cisco 2950G 24 Software Configuration Guide - Page 257

Chapter 10 Configuring LRE Configuring LRE Ports Use the show controllers lre privileged EXEC commands to display the LRE link statistics and profile information on the LRE ports. For information about these commands, refer to the switch command reference. Assigning a Profile to a Specific LRE Port You can set profiles on a per-port basis. You can assign the same profile or different profiles to the LRE ports on the switch. The default active profile on all LRE ports is LRE-10. The switch resets the ports with the updated profile settings when changed. Beginning in privileged EXEC mode, follow these steps to assign a profile to a specific LRE port: Step 1 Step 2 Step 3 Step 4 Step 5 Command configure terminal interface LRE-interface profile profile_name end show controllers lre profile details Purpose Enter global configuration mode. Enter interface configuration mode, and enter the number of the LRE port to be configured. Enter the port profile name (select from the list in Table 10-1). Return to privileged EXEC mode. Verify the change. Use the show controllers lre privileged EXEC command to display the LRE link statistics and profile information on the LRE ports. For information about these commands, refer to the switch command reference. Assigning a Global Sequence to All LRE Ports Global sequences are set on a switch-wide basis. If you assign a global sequence to the switch, it over-rides any previously or subsequently set profiles. (For further information on sequence and profile precendence, see Guidelines for Using LRE Profiles, page 10-7.) Changes to the global sequence settings are immediately put in effect, and the global mode automatically becomes the active mode. Beginning in privileged EXEC mode, follow these steps to assign a global sequence to the LRE ports: Step 1 Step 2 Step 3 Step 4 Command Purpose configure terminal Enter global configuration mode. lre rate selection sequence sequence_name Enter the global sequence name. Select from the list in Table 10-2. end Return to privileged EXEC mode. show controllers lre status sequence Verify the change. Use the show controllers lre status sequence details privileged EXEC commands to display the LRE link statistics and sequence information on the LRE ports. For information about these commands, refer to the switch command reference. 78-14982-01 Catalyst 2950 Desktop Switch Software Configuration Guide 10-9