Cisco 2950G 24 Software Configuration Guide - Page 233
Step 2, Catalyst 2950 Desktop Switch Software Configuration Guide,
UPC - 746320687711
View all Cisco 2950G 24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
Chapter 9 Configuring the Switch Interfaces Using the Interface Command Step 2 Enter configuration commands, one per line. End with CNTL/Z. Switch(config)# Enter the interface global configuration command. Identify the interface type and the number of the connector. In this example, Gigabit Ethernet interface 0/1 is selected: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# Note You do not need to add a space between the interface type and interface number. For example, in the preceding line, you can specify either gigabitethernet 0/1, gigabitethernet0/1, gi 0/1, or gi0/1. Step 3 Step 4 Follow each interface command with the interface configuration commands your particular interface requires. The commands you enter define the protocols and applications that will run on the interface. The commands are collected and applied to the interface when you enter another interface command or enter end to return to privileged EXEC mode. You can also configure a range of interfaces by using the interface range or interface range macro global configuration commands. Interfaces configured in a range must be the same type and must be configured with the same feature options. After you configure an interface, verify its status by using the show privileged EXEC commands listed in the "Monitoring and Maintaining the Interfaces" section on page 9-16. Enter the show interfaces privileged EXEC command to see a list of all interfaces on or configured for the switch. A report is provided for each interface that the device supports or for the specified interface: Switch# show interfaces Vlan1 is up, line protocol is up Hardware is EtherSVI, address is 0000.0000.0000 (bia 0000.0000.00 Internet address is 10.1.1.64/24 MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:35, output 2d14h, output hang never Last clearing of "show interface" counters never Queueing strategy: fifo Output queue 0/40, 1 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 264251 packets input, 163850228 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 380 packets output, 26796 bytes, 0 underruns 0 output errors, 0 interface resets 0 output buffer failures, 0 output buffers swapped out FastEthernet0/1 is up, line protocol is down Hardware is Fast Ethernet, address is 0000.0000.0001 (bia 0000.00 MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Auto-duplex, Auto-speed input flow-control is off, output flow-control is off ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never Last clearing of "show interface" counters never 78-14982-01 Catalyst 2950 Desktop Switch Software Configuration Guide 9-5