Cisco 2950G 24 Software Configuration Guide - Page 228

Displaying 802.1X Statistics and Status Chapter 8 Configuring 802.1X Port-Based Authentication Step 4 Step 5 Step 6 Command end show dot1x interface interface-id copy running-config startup-config Purpose Return to privileged EXEC mode. Verify your entries. (Optional) Save your entries in the configuration file. To disable multiple hosts on the port, use the no dot1x multiple-hosts interface configuration command. This example shows how to enable 802.1X on Fast Ethernet interface 0/1 and to allow multiple hosts: Switch(config)# interface fastethernet0/1 Switch(config-if)# dot1x port-control auto Switch(config-if)# dot1x multiple-hosts Resetting the 802.1X Configuration to the Default Values Beginning in privileged EXEC mode, follow these steps to reset the 802.1X configuration to the default values: Step 1 Step 2 Step 3 Step 4 Step 5 Command configure terminal dot1x default end show dot1x copy running-config startup-config Purpose Enter global configuration mode. Reset the configurable 802.1X parameters to the default values. Return to privileged EXEC mode. Verify your entries. (Optional) Save your entries in the configuration file. Displaying 802.1X Statistics and Status To display 802.1X statistics for all interfaces, use the show dot1x statistics privileged EXEC command. To display 802.1X statistics for a specific interface, use the show dot1x statistics interface interface-id privileged EXEC command. To display the 802.1X administrative and operational status for the switch, use the show dot1x privileged EXEC command. To display the 802.1X administrative and operational status for a specific interface, use the show dot1x interface interface-id privileged EXEC command. For detailed information about the fields in these displays, refer to the command reference for this release. 8-14 Catalyst 2950 Desktop Switch Software Configuration Guide 78-14982-01