Cisco AIR-LAP1131AG-E-K9 Hardware Installation Guide - Page 52
Checking the Autonomous Access Point LEDs
View all Cisco AIR-LAP1131AG-E-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Checking the Autonomous Access Point LEDs Chapter 3 Troubleshooting Autonomous Access Points Checking the Autonomous Access Point LEDs If your autonomous access point is not working properly, check the Status LED on the top panel or the Ethernet and Radio LEDs in the cable bay area. You can use the LED indications to quickly assess the unit's status. Figure 3-1 shows the access point LEDs (for additional information refer to the Event Log using the access point browser interface). Figure 3-1 Access Point LEDs 1 2 121802 3 4 1 Status LED 2 Access point cover 3 Ethernet LED 4 Radio LED Note To view the Ethernet and Radio LEDs you must open the access point cover (refer to the "Opening the Access Point Cover" section on page 2-11). Note When the access point cover is opened, the Status LED colors are not visible. Note Regarding LED status colors, it is expected that there will be small variations in color intensity and hue from unit to unit. This is within the normal range of the LED manufacturer's specifications and is not a defect. Cisco Aironet 1130AG Series Access Point Hardware Installation Guide 3-2 OL-8369-05