Clifford GP1000T Owners Guide - Page 26
begin at step 5 by entering the column number first
View all Clifford GP1000T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
6. Feature change - Press the button on the remote. If the system chirps once, the feature has just turned off or switched to the first setting in the grid slot for this feature.; if the system chips twice, the feature has just turned on or switched to the second setting in the grid slot. If the feature has more than two settings, continue pressing the on the remote to toggle through the settings (e.g. if the feature has 1 through 5 settings, the system will chirp 1 through 5 times for each setting selected). If you continue to press and release the remote the feature setting will wrap back around to the first setting again. (e.g. if the feature has 3 settings you will hear, 1 chirp, 2, chirps, 3 chirps, 1 chirp, 2 chirps, etc). To advance to another feature in the same column, press the same number of times as the desired feature with- in 60 seconds; to change a feature in a different column begin at step 5 by entering the column number first and then the feature select in step 6. note: Refer to the Feature Descriptions sections of this guide for important notes and descriptions of the system features and programming. 7. Exit programming - To exit programming mode turn the ignition off or wait 60 seconds without pressing the Valet® switch. The siren will chirp three times to indicate programming mode has been exited. After you change a feature setting, the feature counter is reset to zero. Hence, to change another feature in the same column you must press the button the same number of times as indicated in the chart below. © 2005 directed electronics, inc. all rights reserved 23