Compaq 1592DMT Compaq Armada 1500 Family of Personal Computers Maintenance and - Page 208
Modem Port Flow Control., Store Telephone Number.
View all Compaq 1592DMT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 208 highlights
Addendum to Compaq Armada 1500 Maintenance and Service Guide Table C-2, AT Commands, Continued Command &Zn=s \G \J \K \Nn \Q Description Store Telephone Number. &Zn=s stores a 40 character string, retrievable by using the ATDS=n command. Assumes location 0 if n is omitted. When used, the &Z command must be the last command on the command line. ): Store s in location 0 1: Store s in location 1 2: Store s in location 2 3: Store s in location 3 Modem Port Flow Control. Applies to normal (ASB) mode only. 0: Returns and "OK" for compatibility (default). 1: NOT SUPPORTED responds ERROR Adjust Bits/s Rate Control. When this feature is enabled, the modem emulates the behavior of modems that force the DTE interface to the line speed (even for error control connections). This feature will help (but not guarantee ) to prevent data loss is one or both DTE interfaces involved do not have flow control. 0: Turn off feature (default). 1: Turn on feature. Set Break Control. /K determines how the modem processes a Break signal received from the local DTE during a connection (online). 0: Reserved, returns ERROR. 1: Reserved, returns ERROR. 2: Reserved, returns ERROR. 3: Reserved, returns ERROR. 4: Reserved, returns ERROR. 5: Modem sheds the break to the remote modem in sequence with the transmitted data, non-destructive/non-expedited (default). Error Control Mode Selection. \Nn determines the type of error control used by the modem when sending or receiving data. 0: Selects normal (speed buffering) mode. No error control (same as &Q6). 1: Selects direct (pass through) mode. 2: MNP* or disconnect mode. The modem attempts to connect using MNP 2- 4 error control procedures. If this fails, the modem disconnects. This is also known as MNP reliable mode. 3: V.42, MNP, or buffer (default). The modem attempts to connect in V.42 error control mode. If this fails, the modem attempts to connect in MNP mode. If this fails, the modem connects in buffer mode and continues operation. This is also known as V.42/MNP auto reliable mode (same as &Q5). 4: V.42 or disconnect. The modem attempts to connect in V.42 error control mode. If this fails, the call will be disconnected. 5: V.42. MNP or buffer (same as \N3). 7: V.42. MNP or buffer (same as \N3). Local Flow Control Selection. Also controllable via &K. 0: Disable flow control. Same as &K0. 1: XON/XOFF software flow control. Same as &K4. 2: CTS-only flow control. This is not supported and the response is ERROR. 3: Hardware flow control (RTS/CTS) (default). Same as &K3. Continued Addendum 255318-001 to Guide 284820-001 25