Craftsman 21221 Operation Manual - Page 194

Fig. U 4 Fig. V 4 1 3 1 3 2 45 ° Right Bevel Positive Stop Adjustment (Fig. V) 1. Set the miter angle to zero degrees. Fully extend the sliding fence completely to the right then pull the bevel detent pin (1) toward the front of the machine. NOTE: When retracting the bevel detent pin, it may be required to shift the miter saw upper arm assembly to the left/right. 2. Loosen the bevel lock handle (2) and tilt the cutting arm completely to the right. 3. Using a combination square, check to see if the blade is 45 ° to the table. 4. To adjust, tilt the cutting arm to zero degrees, loosen the Iocknut (3) and turn the bolt (4) in or out accordingly. 5. Tilt the cutting arm back to the right and recheck alignment. 6. Repeat steps until the blade is 45 ° to the table. Once alignment is achieved, tighten the Iocknut (3) to secure the positive stop bolt. 33.9° Left & Right Bevel Adjustment (Fig. W) 1. Set the miter angle to zero degree. Fully extend both sliding fences. 2. Loosen the bevel lock handle and tilt cutting arm to the 33.9 ° left bevel positive stop by pushing in on the bevel detent pin toward the rear of the machine. 3. Using a combination square, check to see if the blade is 33.9 ° to the table. 4. To adjust, turn the screw in or out with a wrench (from the locations shown below) until the blade is 33.9 ° to the table. 5. Repeat steps for the right bevel 33.9 -0bevel adjustment. Fig. W For 33.9 ° left ._ bevel positive stop adjustment, insert wrench here 26