Craftsman 21221 Operation Manual - Page 79
Complies with 21CFR
View all Craftsman 21221 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
ALIGNING THE LASER BEAM (FIG. • NOTE: All the adjustments for the O, P) operation of this machine have WARNING I been completed at the factory. Due to normal wear and use, For your own safety, never connect some occasional readjustments the plug to power source outlet until all the adjustment steps may be necessary. • CAUTION-Use of controls or are complete and you have read adjustments or performance of and understood the safety and procedures other than those operational instructions. specified herein may result in The laser beam must always be hazardous radiation exposure. correctly aligned with the blade to • CAUTION-The use of optical ensure straight, even cutting. instruments with this product will Your tool is equipped with the Laser increase eye hazard. Trac ®cutting guide using Class II laser beam. The laser beam will enable to • Do not attempt to repair or disassemble the laser. If preview the saw blade path on the unqualified persons attempt stock to be cut before starting the miter to repair this laser product, saw. This laser guide is powered by the serious injury may result. Any transformed alternating current supply repair required on this laser directly through the power lead. The product should be performed saw must be connected to the power source and the laser on/off switch must be turned on for the laser line by authorized service center personnel. to show. A. Check Laser Beam Alignment. WARNING I AVOID DIRECT EYE CONTACT • Laser radiated when laser guide 1. Mark a 90 ° straight line across a board to serve as a "pattern line" to test laser alignment. Lay the board on the miter table. is turned on. Avoid direct eye 2. Plug saw into outlet and turn on the contact. Always un-plug the miter laser beam and line it up with the saw from power source before pattern line. making any adjustments. 3. Lower saw blade to pattern line and • Laser Warning Label: Max output if blade is not flush with the pattern