D-Link DGS-3620-52P Web UI Reference Guide - Page 230

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide Stub Interface Use the drop-down menu to enable or disable this interface to be a STUB interface. If this interface configures a stub interface, then no PIM for IPv6 packets are sent out this interface, and any received PIM for IPv6 packets are ignored. By default, an interface is not stub interface. Click the PIM > PIM for IPv6 > PIM for IPv6 Candidate BSR Settings, as shown below: Figure 5-896 PIM for IPv6 Candidate BSR Settings window The fields that can be configured are described below: Parameter Description Interface Name Enter the IP interface used in this configuration. State Use the drop-down menu to enable or disable the input interface as a Candidate BSR. Priority (0-255) Enter the Candidate BSR priority value. Hash Mask Len (0-128) Enter the length (in bits) of the mask. It makes use of a hash function for the case where a group range has multiple RPs with the same priority. Click the Apply button to accept the changes made. PIM for IPv6 Candidate RP Settings This window is used to set the candidate rendezvous point (RP) related parameters. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for IPv6 Candidate RP Settings, as shown below: Figure 5-907 PIM for IPv6 Candidate RP Settings window The fields that can be configured are described below: 220