D-Link DGS-3620-52P Web UI Reference Guide - Page 43

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide BOOTP protocol allows IP addresses, network masks, and default gateways to be assigned by a central BOOTP server. If this option is set, the Switch will first look for a BOOTP server to provide it with this information before using the default or previously entered settings. The following table will describe the fields that are about the System Interface. Parameter Description Interface Name Display the System interface name. Management VLAN Name Displays the VLAN Name to which the interface belongs. Interface Admin State Use the drop-down menu to enable or disable the configuration on this interface. If the state is disabled, the IP interface cannot be accessed. IP Address This field allows the entry of an IPv4 address to be assigned to this IP interface. Subnet Mask A Bitmask that determines the extent of the subnet that the Switch is on. Should be of the form xxx.xxx.xxx.xxx, where each xxx is a number (represented in decimal) between 0 and 255. The value should be 255.0.0.0 for a Class A network, 255.255.0.0 for a Class B network, and 255.255.255.0 for a Class C network, but custom subnet masks are allowed. Gateway IP address that determines where packets with a destination address outside the current subnet should be sent. This is usually the address of a router or a host acting as an IP gateway. If your network is not part of an intranet, or you do not want the Switch to be accessible outside your local network, you can leave this field unchanged. Click the Apply button to accept the changes made. Interface Settings Users can display the Switch's current IP interface settings. To view the following window, click Management > IP Interface > Interface Settings, as show below: Figure 3-8 Interface Settings window The fields that can be configured are described below: Parameter Description Interface Name Enter the name of the IP interface to search for. Click the Find button to locate a specific entry based on the information entered. Click the Add button to add a new entry based on the information entered. Click the Delete All button to remove all the entries listed. Click the IPv4 Edit button to edit the IPv4 settings for the specific entry. Click the IPv6 Edit button to edit the IPv6 settings for the specific entry. Click the Delete button to remove the specific entry. 33