D-Link DGS-3620-52P Web UI Reference Guide - Page 244

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide To view the following window, click L3 Features > BGP > BGP Aggregate Address Settings, as shown below: Figure 5-20 BGP Aggregate Address Settings window The fields that can be configured are described below: Parameter Description IP Address Enter the IP network address to be aggregated. Netmask Enter the netmask of the IP network address to be aggregated. Summary Only Tick this check box to stop more specific routes from being advertised. The default setting is un-ticked. AS Set Tick this check box to generate Autonomous System set path information. The default setting is un-ticked. Click the Add button to add a new entry based on the information entered. Click the Find button to locate a specific entry based on the information entered. Click the Delete All button to remove all the entries listed. Click the View All button to display all the existing entries. Click the Delete button to remove the specific entry. BGP Network Settings This window is used to specify the network advertised by the Border Gateway Protocol (BGP). To view the following window, click L3 Features > BGP > BGP Network Settings, as shown below: Figure 5-10921 BGP Network Settings window The fields that can be configured are described below: Parameter Description IP Address Enter the IP address of the local network that BGP will advertise. Netmask Enter the netmask of the local network that BGP will advertise. Route Map Name Enter the route map to be applied to the advertised networks. If not specified, all networks are advertised. Click the Add button to add a new entry based on the information entered. 234