D-Link DGS-3620-52P Web UI Reference Guide - Page 452

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide Figure 11-23 sFlow Counter Poller Settings The fields that can be configured are described below: Parameter Description From Port / To Port Use the drop-down menus to specify the list of ports to be configured. Analyzer Server ID The analyzer server ID specifies the ID of a server analyzer where the packet will be forwarded. Interval The maximum number of seconds between successive samples of the counters. Click the Apply button to accept the changes made. Click the Delete All button to remove all the entries listed. Click the Edit button to re-configure the specific entry. Click the Delete button to remove the specific entry. Ping Broadcast Ping Relay Settings This window is used to enable or disable broadcast ping reply state, device will reply broadcast ping request. To view this window, click Monitoring > Ping > Broadcast Ping Relay Settings as shown below: Figure 11-24 Broadcast Ping Relay Settings window The fields that can be configured are described below: Parameter Description Broadcast Ping Relay State Click the radio buttons to enable or disable broadcast ping relay state. Click the Apply button to accept the changes made. Ping Test Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds to or "echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other nodes on the network. To view this window, click Monitoring > Ping > Ping Test as shown below: 442