D-Link DSN-656 User Manual - Page 139
D-Link Document - User Manual, EMS Events, Copyright@2014 D-Link System, Inc. All Rights Reserved.
View all D-Link DSN-656 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
D-Link Document - User Manual INFO INFO ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR ERROR INFO INFO INFO INFO INFO INFO ECC none SCSI bus reset SCSI host error SATA enable device fail SATA EDMA mem fail SATA remap mem fail SATA PRD mem fail SATA revision id fail SATA set reg fail SATA init fail SATA diag fail Mode ID fail SATA chip count error SAS port reply error SAS unknown port reply error FC port reply error FC unknown port reply error Port linkup Port linkdown Non-ECC memory is installed Received SCSI Bus Reset event at the SCSI Bus SCSI Host allocation failed Failed to enable the SATA pci device Failed to allocate memory for SATA EDMA Failed to remap SATA memory io space Failed to init SATA PRD memory manager Failed to get SATA revision id Failed to set SATA register Core failed to initialize the SATA adapter SATA Adapter diagnostics failed SATA Mode ID failed SATA Chip count error SAS HBA port reply terminated abnormally SAS frontend reply terminated abnormally FC HBA port reply terminated abnormally FC frontend reply terminated abnormally The Port link status is changed to Up. The Port link status is changed to Down. EMS Events Level INFO ERROR INFO ERROR WARNING INFO ERROR INFO ERROR ERROR WARNING ERROR ERROR ERROR WARNING WARNING ERROR Type Power install Power absent Power restore Power fail Power detect Fan restore Fan fail Fan install Fan not present Fan over speed Thermal level 1 Thermal level 2 Thermal level 2 shutdown Thermal level 2 CTR shutdown Thermal ignore value Voltage level 1 Voltage level 2 Description Power() is installed Power() is absent Power() is restored to work. Power() is not functioning PSU signal detection() Fan() is restored to work. Fan() is not functioning Fan() is installed Fan() is not present Fan() is over speed System temperature() is higher. System Overheated()!!! System Overheated()!!! The system will auto- shutdown immediately. The controller will auto shutdown immediately, reason [Overheated()]. Unable to update thermal value on System voltage() is higher/lower. System voltages() failed!!! Copyright@2014 D-Link System, Inc. All Rights Reserved. 139