D-Link DSN-656 User Manual - Page 54
iSCSI IP Address Settings, Specify a Static IP
View all D-Link DSN-656 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
D-Link Document - User Manual 。 VLAN ID: VLAN ID is a 12-bit number. Its range is from 2 to 4094, while 0, 1, and 4095 are reserved for special purposes. 。 Priority: The PCP (Priority Code Point) is a 3-bit number and reserved for QoS. The definition complies with IEEE 802.1p protocol, ranging from 0 to 7, with 0 as the default value. In normal cases, you don't need to set this value. Using the default will do just fine. TIP: If iSCSI ports are assigned with VLAN ID before creating aggregation takes place, aggregation will remove VLAN ID. You need to repeat the steps to set VLAN ID for the aggregation group. ▼ iSCSI IP Address Settings: It can assign an iSCSI IP address of the iSCSI data port. There are two options: Use DHCP to acquire an IP address automatically or Specify a Static IP Address to set the IP address manually. ▼ Make Default Gateway: Set the gateway of the IP address as default gateway. There can be only one default gateway. To remove the default gateway, click ▼ Remove Default Gateway. ▼ Enable jumbo frames: It can enable the MTU (Maximum Transmission Unit) size. The maximum jumbo frame size is 3900 bytes. To disable jumbo frames, click ▼ Disable Jumbo Frames. Copyright@2014 D-Link System, Inc. All Rights Reserved. 54