D-Link DWS-3024L User Manual - Page 119
Enabling AP Debugging, Management > Advanced, Advanced
View all D-Link DWS-3024L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
6 Managing and Maintaining D-Link Access Points Management > Advanced page. From the Advanced page, you can also manually change the RF channel and power for each radio on an AP. Figure 56. Advanced AP Management Each AP managed by the D-Link Unified Switch is listed by its MAC address and location. The location is based on the value in the RADIUS or local Valid AP database. Table 21 describes the Advanced features you can configure for the AP. Table 21. Advanced AP Management Field Debug Channel Power Description To help you troubleshoot, you can enable Telnet access to the AP so that you can debug the device from the CLI. The Debug field shows the debug status and can be one of the following: • Disabled • Set Requested • Set in Progress • Enabled To change the status, click the Debug status link. The Managed AP Debug page appears. Table 22 describes the fields on the new page. Click the Channel link to access the Managed AP Channel/Power Adjust page. From that page, you can set a new channel for Radio 1 or Radio 2. The available channels depend on the radio mode and country in which the APs operate. Table 23 describes the fields on the new page. Click the Power link to access the Managed AP Channel/Power Adjust page. From that page, you can set a new power level for the AP. Table 23 describes the fields on the new page. Enabling AP Debugging You can enable debugging on an AP to allow Telnet access to the access point. Once you Telnet to the AP, you can issue commands from the CLI to help you troubleshoot. Performing Advanced Access Point Management 119