D-Link DWS-3024L User Manual - Page 71
Setting the Switch IP Address in the D-Link Access Point, Submit
View all D-Link DWS-3024L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
4 Installing the D-Link Unified Access System 6. Click Submit to apply the changes to the switch. To view information about whether the switch successfully polled the IP address you entered, click the Monitoring > Global > IP Discovery tab. The following example shows how to add an address to the L3 Discovery list by using the CLI. 1. From a Telnet, SSH, or serial connection, log on to the D-Link Unified Switch and enter the Wireless Configuration mode. (switch-prompt) >enable Password: (switch-prompt) #config (switch-prompt) (Config)#wireless 2. Add the IP address of a peer switch or AP to the discovery list: (switch-prompt) (Config-wireless)#discovery ip-list 192.168.6.211 From the CLI, you can only add one IP address at a time. 3. Enter CTRL + Z to return to Privileged EXEC mode. 4. Save the changes to the configuration file: (switch-prompt) #write This operation may take a few minutes. Management interfaces will not be available during this time. Are you sure you want to save? (y/n) y Configuration Saved! To check the managed AP status from the Unified Switch CLI, enter the following command: (switch-prompt) #show wireless ap status Setting the Switch IP Address in the D-Link Access Point You can connect to the D-Link Access Point CLI and statically set the IP address or DNS name of the D-Link Unified Switch. You can configure up to four D-Link Unified Switches Discovering Access Points and Peer Switches 71