D-Link DWS-3024L User Manual - Page 158

D-Link Unified Access System User Manual To delete a profile, select the profile and click Delete. NOTE: You cannot delete a profile if the switch is managing an access point that is currently using that profile. To access an existing profile, click the tab with the name of the profile. When you add a new profile, it has the default AP settings, which are listed in Appendix A. When you copy a profile, it has the AP settings configured in the original profile. To modify any settings within a profile, click the Global, Radio, Network or QoS settings for the profile you select and update the appropriate fields. For more information about the fields on the Global page, see "Configuring AAA and RADIUS Settings" on page 85. For more information about the fields on the Radio page, see "Configuring Wireless Radio Settings" on page 87. For more information about the fields on the Network page, see "Configuring SSID Settings" on page 92. For more information about the fields on the QoS page, see "Configuring QoS" on page 163. Applying an AP Profile After you update an AP Profile on the Unified Switch, the changes are not applied to the access points that use that profile until you explicitly apply the profile on the Access Point Profile Summary page or reset the APs that use the profile. NOTE: When you change the VLAN ID for a wireless network, the AP might temporary lose its DHCP-assigned IP address when you apply the updated profile. If this occurs, the AP goes into Standalone mode. As soon as the AP regains its IP address from the DHCP server on your network, it resumes normal operation as a managed AP. You might also see this behavior when you enable or disable a VAP (SSID) and re-apply the AP profile. To apply the profile changes to all access points that use a profile, select the profile and click Apply, as Figure 71 shows. Figure 71. Applying the AP Profile Selected Profile to Apply 158 © 2001- 2008 D-Link Corporation. All Rights Reserved.