Dell Alienware x15 R2 Service Manual - Page 59
Installing the power button
View all Dell Alienware x15 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
2. Remove the base cover. 3. Remove the battery. 4. Remove the wireless card. 5. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable. 6. Remove the fans. 7. Remove the rear I/O-cover. 8. Remove the solid-state drive bracket. 9. Follow the procedure from step 1 to step 16 in Removing the system board. NOTE: The system board can be removed and installed along with the heat sink. This simplifies the removal and installation procedure and avoids breaking the thermal bond between the system board and heat sink. About this task The following image(s) indicate the location of the power button and provides a visual representation of the removal procedure. Steps 1. Remove the two (M2x1.9) screws that secure the power-button bracket to the palm-rest and keyboard assembly. 2. Remove the two (M1.2x1.5) screws that secure the power-button bracket to the palm-rest and keyboard assembly. 3. Lift the power-button bracket off the power button. 4. Lift the power button, along with its cable, off the palm-rest and keyboard assembly. Installing the power button Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the power button and provides a visual representation of the installation procedure. 59