Dell Alienware x17 R2 Service Manual - Page 48
Installing the touchpad
View all Dell Alienware x17 R2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
4. Lift the keyboard-controller board cable off the palm-rest and keyboard assembly. 5. Open the latches and disconnect the touchpad cable from the keyboard-controller board and the touchpad. 6. Disconnect the touchpad-light cable from the touchpad assembly. 7. Remove the four screws (M1.6x2) that secure the touchpad assembly to the palm-rest and keyboard assembly. 8. At an angle, slide and lift the touchpad assembly from the slot on the palm-rest and keyboard assembly. Installing the touchpad Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following image(s) indicate the location of the touchpad and provides a visual representation of the installation procedure. Steps 1. At an angle slide the touchpad assembly into the slot on the palm-rest and keyboard assembly. 2. Turn the computer over and open the display to ensure that the touchpad is equally aligned on all sides. NOTE: The following image shows the proper touchpad alignment for your computer. 48