Dell Force10 S25-01-GE-24T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1211

show cam layer3-qos e Display the Layer 3 QoS CAM entries. Syntax Parameters show cam layer3-qos {[linecard number port-set number] | [interface interface]} [summary] linecard number port-set number interface interface summary Enter the keyword linecard followed by the line card slot number. E-Series Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on a E300. Enter the keyword port-set followed by the line card's port pipe. Range: 0 or 1 Enter the keyword interface followed by one of the keywords below and slot/port or number information: • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter the keyword summary to display only the total number of CAM entries. Defaults No default behavior or values Command Modes EXEC Command History Example Version 6.5.1.0 Introduced on E-Series Figure 48-5. show cam layer3-qos linecard interface Command Output Force10#sh cam layer3-qos interface gigabitethernet 2/1 Cam Port Dscp Proto Tcp Src Dst SrcIp DstIp DSCP Queue Index Flag Port Port Marking ---- 23488 1 0 0 0x0 0 0 0.0.0.0/0 0.0.0.0/0 - TRUST-DSCP Force10# In these figures outputs, note that: • The entry TRUST-DSCP in the Queue column indicates that the trust diffserv is configured on the policy-map. • A hyphen (-) entry in the DSCP Marking column indicates that there is no DSCP marking. • In the Proto column (Protocol), IP, ICMP, UDP, and TCP strings are displayed. For other protocols, the corresponding protocol number is displayed. Quality of Service (QoS) | 1211