Dell Force10 S25-01-GE-24T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 248

www.dell.com | support.dell.com mac access-list standard c e s Name a new or existing MAC access control list (MAC ACL) and enter the MAC ACCESS LIST mode to configure a standard MAC ACL. See Commands Common to all ACL Types and Common MAC Access List Commands. Syntax mac access-list standard mac-list-name Parameters mac-list-name Enter a text string as the name of the standard MAC access list (140 character maximum). Defaults Not configured Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Support added for S-Series Support added for C-Series Introduced for E-Series Usage Information FTOS supports one ingress and one egress MAC ACL per interface. Prior to 7.8.1.0, names are up to 16 characters long. The number of entries allowed per ACL is hardware-dependent. Refer to your line card documentation for detailed specification on entries allowed per ACL. C-Series and S-Series support ingress ACLs only. Example Figure 9-7. Command Example: mac-access-list standard Force10(conf)#mac-access-list access-list standard TestMAC Force10(config-std-macl)#? deny Specify packets to reject description List description exit Exit from access-list configuration mode no Negate a command or set its defaults permit Specify packets to forward remark Specify access-list entry remark seq Sequence numbers show Show Standard ACL configuration permit c e s Configure a filter to forward packets from a specific source MAC address. Syntax permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or 248 | Access Control Lists (ACL)