Dell Force10 S25-01-GE-24T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 514

www.dell.com | support.dell.com Command Mode conf-callhome-policy Command History Version 7.8.1.0 Introduced on C-Series and E-Series Related Commands policy policy-test-list test-condition (comparing samples) test-condition (comparison to a value) test-condition message-text (deprecated) test-limit Create a policy with a name and enter config-callhome-policy-name mode. Name a policy test list and enter the config-callhome-actionlist-name mode. Collect multiple samples of a statistic and compare them using the specified comparator and hurdle value. Collect a sample of a designated statistic and then compare it to the designated number. Search for a stated value in the output of the designated show command or message type. Set the number of times that the test list should be executed. server c e Use this command to create a server name to be associated with a particular recipient. Syntax server name To remove a server and the associated recipient, use the no server name command. Parameters name Enter the name of the server in alphanumeric format, up to 25 characters long. Defaults Force10 Command Mode CONFIGURATION Server (conf-callhome) Command History Version 7.6.1.0 Version 6.3.1.0 Introduced on C-Series Introduced for E-Series Example Figure 20-2. server (FTSA) Command Example Force10(conf-callhome)# Force10(conf-callhome)#server freedom_bird Force10(conf-callhome-freedom_bird)#? Usage The Dell Force10 server name is configured for FTSA messages to be sent by default to Dell Force10 Support at [email protected]. If you want to change that address, enter the command server Force10. You will be placed at that server-specific prompt (conf-callhome-Force10), where you would then use the recipient command to enter a new address. In addition to modifying the Dell Force10 server recipient, you can identify up to four more server names and associated recipients. 514 | Force10 Service Agent