Dell Force10 S25-01-GE-24T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 422
Important Points to Remember, cam-profile, 10M L2, 10M L2 IPv6 Switching, 40M L2 IPv6-IPv4
View all Dell Force10 S25-01-GE-24T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 422 highlights
www.dell.com | support.dell.com Important Points to Remember • The Default CAM-profile is supported on E-Series ExaScale with FTOS version 8.1.1.0 and later. • The recommended, pre-defined CAM-profile templates are supported on E-Series ExaScale with FTOS version 8.2.1.0 and later. • The CAM-profile template is applied to entire system. You must save the running-configuration to enable the change. Saving the running-configuration also ensures that the CAM-profile selected remains in the case of a reboot. • All components in the chassis must have the same CAM-profile and microcode. The profile and microcode loaded on the primary RPM determines the profile that is required on all other chassis components. • If a newly installed line card has a profile different from the primary RPM, the card reboots so that it can load the proper profile. • If the standby RPM has a profile different from the primary RPM, the RPM reboots so that it can load the proper profile. • Enabling a CAM-profile immediately replaces the existing CAM-profile. You will be prompted to save the running-configuration and reload the system to implement the new CAM-profile. The CAM-profile commands are: cam-profile template [10M-CAM] ex Select a pre-defined CAM-profile template or create a new CAM-profile template. Syntax cam-profile template {10M-CAM} Parameters template Choose one of the following CAM profiles: • 10M L2 to support IPv4 Layer 2 switching on line cards with 10M CAM. • 10M L2 IPv6 Switching to support IPv6 Layer 2 switching on line cards with 10M CAM. • 40M L2 IPv6-IPv4 to support IPv4 and IPv6 Layer 2 routing on line cards with 40M CAM. • 40M L2 IPv4Only to support IPv4 Layer 2 routing on line cards with 40M CAM. • VRF to support Virtual Routing and Forwarding (VRF). • MAX-IPv4-FIB to allocate the maximum space supported for IPv4 FIB support. • Enter a 16 character string used as a template name to create a new template. Defaults Default Command Modes CONFIGURATION Command History Version 8.2.1.0 Introduced on E-Series ExaScale 422 | Content Addressable Memory (CAM) for ExaScale