Dell Force10 S25-01-GE-24T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 1372

www.dell.com | support.dell.com snmp-server view c e s Configure an SNMPv3 view. Syntax snmp-server view view-name oid-tree {included | excluded} To remove an SNMPv3 view, use the no snmp-server view view-name oid-tree {included | excluded} command. Parameters view-name oid-tree included excluded Enter the name of the view (not to exceed 20 characters). Enter the OID sub tree for the view (not to exceed 20 characters). (OPTIONAL) Enter the keyword included to include the MIB family in the view. (OPTIONAL) Enter the keyword excluded to exclude the MIB family in the view. Defaults No default behavior or values Command Modes CONFIGURATION Command History Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command Usage Information The oid-tree variable is a full sub-tree starting from 1.3.6 and can not specify the name of a sub-tree or a MIB. The following example configures a view named rview that allows access to all objects under 1.3.6.1: Example Figure 55-10. snmp-server view Command Example Force10# conf Force10#(conf) snmp-server view rview 1.3.6.1 included Related Commands show running-config snmp Display the SNMP running configuration snmp trap link-status c e s Enable the interface to send SNMP link traps, which indicate whether the interface is up or down. Syntax snmp trap link-status To disable sending link trap messages, enter no snmp trap link-status. Defaults Enabled. Command Modes INTERFACE Command History Version 7.6.1.0 Support added for S-Series 1372 | SNMP and Syslog