Dell Force10 S25-01-GE-24T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 351

neighbor subnet c e s Enable passive peering so that the members of the peer group are dynamic Syntax neighbor peer-group-name subnet subnet-number mask To remove passive peering, use the no neighbor peer-group-name subnet subnet-number mask command. Parameters subnet-number mask Enter a subnet number in dotted decimal format (A.B.C.D.) as the allowable range of addresses included in the Peer group. To allow all addresses, enter 0.0.0.0/0. Enter a prefix mask in / prefix-length format (/x). Defaults Not configured. Command Modes ROUTER BGP Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series neighbor timers c e s Set keepalive and hold time timers for a BGP neighbor or a peer group. Syntax neighbor {ip-address | peer-group-name} timers keepalive holdtime To return to the default values, use the no neighbor {ip-address | peer-group-name} timers command. Parameters ip-address peer-group-name keepalive holdtime Enter the IP address of the peer router in dotted decimal format. Enter the name of the peer group to set the timers for all routers within the peer group. Enter a number for the time interval, in seconds, between keepalive messages sent to the neighbor routers. Range: 1 to 65535 Default: 60 seconds Enter a number for the time interval, in seconds, between the last keepalive message and declaring the router dead. Range: 3 to 65535 Default: 180 seconds Defaults keepalive = 60 seconds; holdtime = 180 seconds. Command Modes ROUTER BGP Usage Timer values configured with the neighbor timers command override the timer values configured with Information the any other command. Border Gateway Protocol IPv4 (BGPv4) | 351