Dell Force10 S25-01-GE-24T FTOS 8.4.2.6 Command Line Reference Guide for the E - Page 384

www.dell.com | support.dell.com Parameters keepalive holdtime Enter a number for the time interval, in seconds, between keepalive messages sent to the neighbor routers. Range: 1 to 65535 Default: 60 seconds Enter a number for the time interval, in seconds, between the last keepalive message and declaring the router dead. Range: 3 to 65535 Default: 180 seconds Defaults No default values or behavior Command Modes ROUTER BGP Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced on S-Series Introduced on C-Series Introduced on E-Series MBGP Commands Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the Internet and connecting multicast topologies between BGP and autonomous systems (AS). FTOS MBGP is implemented as per IETF RFC 2828. FTOS version 7.8.1.0 and later support MBGP for IPv6 on et and c platforms. FTOS version 7.8.1.0 and later supports MBGP for IPv4 Multicast only on the s platform. FTOS version 8.2.1.0 and later support MBGP on the E-Series ExaScale ex platform. The MBGP commands are: • address family ipv4 multicast (MBGP) • aggregate-address • bgp dampening • bgp soft-reconfig-backup • clear ip bgp dampening • clear ip bgp flap-statistics • clear ip bgp ipv4 multicast soft • debug ip bgp dampening • debug ip bgp dampening • debug ip bgp dampening • debug ip bgp peer-group updates • debug ip bgp ipv4 unicast soft-reconfiguration • debug ip bgp updates • distance bgp • neighbor activate • neighbor advertisement-interval 384 | Border Gateway Protocol IPv4 (BGPv4)