Dell Force10 S4810P S4810 Configuration Guide, FTOS 8.3.10.1 - Page 131

Create a route map Route maps, ACLs, and prefix lists are similar in composition because all three contain filters, but route map filters are do not contain the permit and deny actions found inACLs and prefix lists. Route map filters match certain routes and set or specify values. To create a route map and enter the ROUTE-MAP mode, use the following command in the CONFIGURATION mode: Command Syntax route-map map-name [permit | deny] [sequence-number] Command Mode CONFIGURATION Purpose Create a route map and assign it a unique name. The optional permit and deny keywords are the action of the route map. The default is permit. The optional parameter seq allows you to assign a sequence number to the route map instance. The default action is permit and the default sequence number starts at 10. When the keyword deny is used in configuring a route map, routes that meet the match filters are not redistributed. To view the configuration, use the show config command in the ROUTE-MAP mode as shown in the example below. FTOS(config-route-map)#show config ! route-map dilling permit 10 FTOS(config-route-map)# You can create multiple instances of this route map by using the sequence number option to place the route maps in the correct order. FTOS processes the route maps with the lowest sequence number first. When a configured route map is applied to a command, likeredistribute, traffic passes through all instances of that route map until a match is found. The following text shows an example with two instances of a route map. FTOS#show route-map route-map zakho, permit, sequence 10 Match clauses: Set clauses: route-map zakho, permit, sequence 20 Match clauses: interface GigabitEthernet 0/1 Set clauses: tag 35 level stub-area FTOS# To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence number to the command syntax as shown in the following example. FTOS(conf)#no route-map zakho 10 FTOS(conf)#end Access Control Lists (ACLs) | 131