Dell Force10 S4810P S4810 Configuration Guide, FTOS 8.3.10.1 - Page 823

Figure 39-7. Displaying How Your Rate Limiting Configuration Affects Traffic FTOS#show interfaces gigabitEthernet 1/1 rate limit Rate limit 300 (50) peak 800 (50) Traffic Monitor 0: normal 300 (50) peak 800 (50) Out of profile yellow 23386960 red 320605113 Traffic Monitor 1: normal NA peak NA Out of profile yellow 0 red 0 Traffic Monitor 2: normal NA peak NA Out of profile yellow 0 red 0 Traffic Monitor 3: normal NA peak NA Out of profile yellow 0 red 0 Traffic Monitor 4: normal NA peak NA Out of profile yellow 0 red 0 Traffic Monitor 5: normal NA peak NA Out of profile yellow 0 red 0 Traffic Monitor 6: normal NA peak NA Out of profile yellow 0 red 0 Traffic Monitor 7: normal NA peak NA Out of profile yellow 0 red 0 Total: yellow 23386960 red 320605113 Configure Port-based Rate Shaping Configure Port-based Rate Limiting is supported only on platform c e s FTOS Behavior: On the C-Series and S-Series, rate shaping is effectively rate limiting because of its smaller buffer size. On the S4810, rate shaping on tagged ports is slightly greater than the configured rate and rate shaping on untagged ports is slightly less than configured rate. Rate shaping buffers, rather than drops, traffic exceeding the specified rate until the buffer is exhausted. If any stream exceeds the configured bandwidth on a continuous basis, it can consume all of the bufer space that is allocated to the port. • Apply rate shaping to outgoing traffic on a port using the command rate shape from INTERFACE mode, as shown in Figure 39-8. • Apply rate shaping to a queue using the command rate-shape from QoS Policy mode. Figure 39-8. Applying Rate Shaping to Outgoing Traffic FTOS#config FTOS(conf)#interface gigabitethernet 1/0 FTOS(conf-if)#rate shape 500 50 FTOS(conf-if)#end FTOS# Quality of Service (QoS) | 823