Dell Force10 S4810P S4810 Configuration Guide, FTOS 8.3.10.1 - Page 280

www.dell.com | support.dell.com Step 3 4 Task Verify that the new CAM profile will be written to the CAM on the next boot. Reload the system. Command Syntax show cam-profile summary reload Command Mode EXEC Privilege EXEC Privilege CAM Allocation c s User Configurable CAM Allocations is available on platforms: Allocate space for IPV4 ACLs and QoS regions, and IPv6 6 ACLs and QoS regions on the C-Series and S-Series by using the cam-acl command in CONFIGURATION mode. The CAM space is allotted in FP blocks.The total space allocated must equal 13 FP blocks. Note that there are 16 FP blocks, but the System Flow requires 3 blocks that cannot be reallocated. The default CAM Allocation settings are: • L3 ACL (ipv4acl): 6 • L2 ACL(l2acl): 5 • IPv6 L3 ACL (ipv6acl): 0 • L3 QoS (ipv4qos): 1 • L2 QoS (l2qos): 1 • L2PT (l2pt): 1 • MAC ACLs (ipmacacl): 2 • ECFMACL (ecfmacl): 0 • VMAN QoS (vman-qos): 0 • VMAN Dual QoS (vman-dual-qos): 0 The following additional CAM Allocation settings are supported on the : • FCoE ACL (fcoeacl): 0 • ISCSI Opt ACL (iscsioptacl): 2 The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use either even or odd numbered ranges. Note: On the S4810, there can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1 Blocks is supported. You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. 280 | Content Addressable Memory (CAM)